We use cookies to help provide you with the best possible online experience. By using this site, you agree that we may store and access cookies on your device.

3Pcs DIY Meter Tester Kit For Capacitance ESR Inductance Resistor NPN PNP Mosfet M168

3Pcs DIY Meter Tester Kit For Capacitance ESR Inductance Resistor NPN PNP Mosfet M168 Arduino SCM & 3D Printer Acc
3Pcs DIY Meter Tester Kit For Capacitance ESR Inductance Resistor NPN PNP Mosfet M168

Feature:

A key measurement operation , auto power off delay . Shutdown current is only 20nA, support battery operation.
Automatic detection PNP and NPN type bipolar transistors , N, P -channel MOSFET, JFET FET , diodes , two diodes, thyristors , resistors , capacitors , inductors. Automatic detection pin definitions.
Measurement of the bipolar transistor current amplification factor (B) and conduction voltage emitter junction (Uf). Darlington transistor may be identified by the amplification factor of the high threshold voltage and high current.
Can be detected inside the bipolar transistor and MOSFET protection diodes and displayed on the screen.
The threshold voltage and the MOSFET gate capacitance measurement.
Support two measuring resistors , the potential can also be measured . If the potentiometer is adjusted to its end , the tester can not distinguish the two ends of the pin and the middle.
Resistance measurement resolution is 0.1Ohm , the highest measurement value of 50MOhm.
Capacitance measurement range from 25pf to 100mF (10UF). Resolution up to 1PF.
Can detect more than 2UF capacitor equivalent series resistance (ESR), with a resolution of 0.01Ohm. This feature is very important for the detection capacitor performance.
You can display symbols of the two diodes in the right direction , also shows the forward voltage drop.
LED detection of diode forward voltage drop higher than normal . Dual LED detected as double diodes. Simultaneous detection of light-emitting diodes will flash.
Each test time is about two seconds , only large capacitance and inductance measurements will take a long time.

Specification:

Measurement Range:
Resistor: 0.5Ω ~ 50MΩ
Capacitor: 30pF ~ 100mF
Inductance: 0.01MH ~ 10H
Working voltage: can use 6FF22 9V Battery, or DC 5.5V ~ 12V via DC socket
Controller: ATmega328 (has been programmed)
Standby current: 0.02uA
Operating current: 25mA

Note:

When measuring 1 uF non-polarity capacitance, attention to short-circuit capacitance between two feet and put off storage of electricity when measuring capacitance, otherwise may damage the instrument, if measuring instrument with electricity is easily to make display show CELL and can't  use normally, we are not responsible for this kind of situation, what you can do is replacing the chip, it is important to note, please!
Please download the install manual file from here or the topic, because it is easily damaged especially for the beginner.

Package included:

3 x Meter Tester DIY Kit (without the battery, not soldered)









Write a review

Note: HTML is not translated!
    Bad           Good

When you order from Bazaargadgets.com, you will receive a confirmation email. Once your order is shipped, you will be emailed the tracking information for your order's shipment. You can choose your preferred shipping method on the Order Information page during the checkout process. Bazaargadgets.com offers four different international shipping methods:

 

Shipping from Chinese Warehouse
Airmail and register airmailAreatime
United States,Canada10-20 business days
Australia,New Zealand,Singapore14-28 business days
United Kingdom, France, Spain, Germany, Netherlands, Japan, Belgium, Denmark, Finland, Ireland, Norway, Portugal, Sweden, Switzerland14-28 business days
Brazil15-35 business days
Russia15-35 business days
Other countries14-28 business days
Priority Direct MailAustria, Belgium,Denmark,Finland,France,Germany,Greece,Italy,Netherland,Portugal,Spain,Sweden7-10 business days
United States6-9 business days
United Kingdom5-10 business days
EMS10-15 business days to worldwide
Expedited Shipping5-8 business days to worldwide

 

NOTE: Netherlands Direct Mail has been combined into the Priority Direct Mail. If you are in a European country; simply choose Priority Direct Mail and it will be shipped via Netherlands Direct Mail.

 

*Expedited shipping can not be used for PO Box addresses

 

In addition, the transit time depends on where you're located. If you want to know more information, please contact the customer service. We will settle your problem as soon as possible. Enjoy shopping!

 

Free Shipping

Purchase over $140 and get Free Shipping on all products.

  • Views: 1434
  • Product Code: 3XSKU136841
  • Availability: In Stock
  • 581 SEK

Tags: 3Pcs, DIY, Meter, Tester, Kit, For, Capacitance, ESR, Inductance, Resistor, NPN, PNP, Mosfet, M168

3Pcs Mech Endstop Switch Kit For CNC 3D Printer RepRap Makerbot Prusa Mendel RAMPS1.4D..
105 SEK
5Pcs ESP8266 Remote Serial Port WIFI Transceiver Wireless ModuleDescription: It run LW..
263 SEK
PWM HHO RC DC Motor Speed Regulator Controller Switch Control Specification:Volt..
118 SEK
AM2302 DHT22 Temperature And Humidity Sensor Module For Arduino SCM Feature: AM2302 Hu..
115 SEK
3D Printer Extruder Thermocouple Double Nozzle Printing Head Feature: Operating voltag..
1,633 SEK