We use cookies to help provide you with the best possible online experience. By using this site, you agree that we may store and access cookies on your device.

10Pcs A3967 V44 EasyDriver Stepper Motor Driver Development Board

10Pcs A3967 V44 EasyDriver Stepper Motor Driver Development Board Arduino SCM & 3D Printer Acc
10Pcs A3967 V44 EasyDriver Stepper Motor Driver Development Board


Stepper motor is usually defined with stepping angle or numbers of steps parameter, the general motor revolution is divided into 200 steps, which is the step angle of 1.8 degrees, EasyDriver has the function of interval subdivision, this driver board subdivision 8 segments, that is, each step of the motor is subdivided into 8 small step, this can be more precise control, that is to say, the EasyDriver needs to 1600 steps to complete a full 360 degree rotation.
a3967slb PWM constant current control micro step distance driving for two phase stepper motor drives which is produced by allegro company in the United State. Its working voltage up to 30v, the drive current is 750ma, a a3967slb can drive a two-phase stepper motor drive and achieve 8 segments.
The chip pwm current control circuit can be added to the pfd voltage and set to slow, fast and mixed three current-decay mode, if the voltage is higher than pfd end 0.6vdd, select slow decay mode. If less than 0.21vdd, then select the fast decay mode. Between the two decay modes is mixed mode. In addition, a3967slb also provide comprehensive protection measures, including transient voltage suppression, overheat protection against current through, under-voltage self-locking function.
No additional other interface circuit between a3967slb and microprocessor, the chip taken easystepper interface, made 8 control lines reduce to 2 ( step and direction ), just need to simply enter the stepper motor control's pulse , its embedded converter can be achieved on the stepper motor control.
A3967slb need some resistors, capacitors to adjust its operating parameters, the whole drive circuit is very simple.


Ms1 and ms2 is the logic input port that selected by subdivide resolution of the stepper motor.
Dir is the selects mouth of running direction of motor.
Reset is used for reset the chip's original value, block all external output.
Step is the pulse input port.
Out1a, out1b, out2a, out2b is the h bridge's two pairs of output ports.
Enable is enable end.
sense1, sense2 is the h bridge's  current sense resistor.
Ref is the reference voltage.
Qnd is logic and power.
Rc1, rc2 is h bridge fixed deadline analog input.

Package included:    

10 x EasyDriver stepper motor driver

Write a review

Note: HTML is not translated!
    Bad           Good


When you order from Bazaargadgets.com, you will receive a confirmation email. Once your order is shipped, you will be emailed the tracking information for your order's shipment. You can choose your preferred shipping method on the Order Information page during the checkout process. Bazaargadgets.com offers four different international shipping methods:


Shipping from Chinese Warehouse
Airmail and register airmailAreatime
United States,Canada10-20 business days
Australia,New Zealand,Singapore14-28 business days
United Kingdom, France, Spain, Germany, Netherlands, Japan, Belgium, Denmark, Finland, Ireland, Norway, Portugal, Sweden, Switzerland14-28 business days
Brazil15-35 business days
Russia15-35 business days
Other countries14-28 business days
Priority Direct MailAustria, Belgium,Denmark,Finland,France,Germany,Greece,Italy,Netherland,Portugal,Spain,Sweden7-10 business days
United States6-9 business days
United Kingdom5-10 business days
EMS10-15 business days to worldwide
Expedited Shipping5-8 business days to worldwide


NOTE: Netherlands Direct Mail has been combined into the Priority Direct Mail. If you are in a European country; simply choose Priority Direct Mail and it will be shipped via Netherlands Direct Mail.


*Expedited shipping can not be used for PO Box addresses


In addition, the transit time depends on where you're located. If you want to know more information, please contact the customer service. We will settle your problem as soon as possible. Enjoy shopping!


Free Shipping

Purchase over $140 and get Free Shipping on all products.

  • Views: 1638
  • Product Code: 10XSKU135375
  • Availability: In Stock
  • 255 SEK

Tags: 10Pcs, A3967, V44, EasyDriver, Stepper, Motor, Driver, Development, Board

10Pcs 4 x 3 Matrix 12 Key Array Membrane Switch Keypad Keyboard For Arduino Descrip..
199 SEK
2Pcs HC-06 Wireless Bluetooth Transceiver RF Main Module Serial For Arduino Descrip..
194 SEK
3Pcs Copper Heat sink Cooling Easy Install For Raspberry Pi Description: A Pure Copper..
99 SEK
5Pcs HC-05 Wireless Bluetooth RF Transceiver Module For Arduino Description: This ..
360 SEK
5Pcs 16Keys 4 x 4 SCM Matrix External Expansion Keyboard Contral BoardFeature: Maximum..
171 SEK